KC310 AF676D 3. Remove the cap screw, lock washer, and washer securing the actuator arm to the throttle control lever. KC309A 2.
Oil Change And Filter For A 2008 Arctic Cat Prowler On Youtube Manual Are OfThe proce- dures found in this manual are of varying difficulty, and certain service procedures in this manual require one or more special tools to be completed.![]()
A. Verify starter cranks engine over at normal speed (approximately 400 RPM). A new spark plug should be tightened 12 turn EngineTransmission once the washer contacts the cylinder head. A used spark plug should be tightened 18 - 14 turn once the washer Oil - Filter contacts the cylinder head. If leakage or damage is detected, take the ATV to an authorized Arctic Cat ATV CAUTION dealer for service. Oil Change And Filter For A 2008 Arctic Cat Prowler On Youtube Free Of TheCarefully rotate the radiator cap counterclockwise to the panel forward until free of the ATV. NOTE: Use a good quality, biodegradable gly- col-based, automotive-type antifreeze. WARNING Never check the coolant level when the engine is hot or the cooling system is under pressure. HeadlightsTail- CHECKINGADJUSTING HEADLIGHT light-Brakelight The headlights can be adjusted vertically and horizon- NOTE: The bulb portion of a headlight is fragile. ![]() Troubleshoot the harness connectors, gear position switch connector, gear position switch, and LCD connector. CHECKING ADJUSTMENT Hydraulic Brake Systems CHECKINGBLEEDING The hydraulic brake systems have been filled and bled at. Burnishing Brake Pads Brake pads (both main and auxiliary) must be burnished to achieve full braking effectiveness. Using an appropriate spanner wrench, tighten the nut to 147 ft-lb (500 model) or 165 ft-lb (5507001000 models). CD966A 4. Remove the shift lever pivot axle nut and remove the axle and shift lever. Account for a spring and two O-rings. FI464A 5. Remove the cap screws and lock nuts securing the front rack to the frame. Remove the cap screws and lock nuts securing the rear rack; then remove the rear rack. Account for the bushings. Remove one shoulder screw and lock nut and three plastic rivets (on each side) securing the rear body panel to the footwells. Oil Change And Filter For A 2008 Arctic Cat Prowler On Youtube Install The CapRemove the gas tank cap and set the rear body panel in position; then install the cap and connect the tail- 1. Account for four handlebar caps. FI465A 3. Remove four reinstallable rivets securing the steer- ing post cover and remove the cover. NOTE: If the slots do not align with the holes in the tie rod ends, tighten the nuts just enough to allow installation of the cotter pins. Place the lower steering post into position; then secure the lower bearing flange to the frame with two cap screws. AF778D AL600D 2. Making sure the double spline is aligned to the slot in the lower coupler, install the EPS output shaft into the lower coupler. KC310 AF676D 3. Remove the cap screw, lock washer, and washer securing the actuator arm to the throttle control lever.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |